![]() ![]() Might not be suitable for: Roofs that aren’t covered with shingles. High rain/snow locations where roof leaks might be a concern. Starlink sells their own Flashing Mount, but you can also find aftermarket products, like the CommDeck Satellite Mounting System pictured above, on Amazon.įlashing Mount is good for: Roof installations. Flashing Mount installations will require not only the Flashing Mount itself, but also an aftermarket J-Mount or Starlink Pivot Mount in order to secure the dish to the Flashing Mount. A Flashing Mount installs under the top layer of shingles and secures to your roof structure for a very strong and leak-free solution. If you want a professional and worry-free roof install, consider a Flashing Mount. The roof is a common place that people will install their Starlink dish. Related: Guide To Using A J Mount With Starlink Flashing Mount – professional looking Starlink roof mount The typical height of a J-Mount is 2-4 feet, so if you need more height beyond the top of your roof, the J-Mount might not be the best option. Might not be suitable for: Areas with a lot of obstructions. ![]() J-Mount is good for: Eave/fascia, roof, exterior wall. ![]() The easiest way is to use a mount adapter, like the Winegard Universal Antenna Mount Adapter pictured above.ĭepending on the inside diameter of your J-Mount, you might need some spacer material or a bolt to fully secure the Starlink mast. The J-Mount solution requires some minor modification to connect with the Starlink mounting tube, depending on which one you buy. You’ll want a J-Mount that has a pipe diameter of around 1.5 inches to use with Starlink, such as the Winegard DS2000A that is pictured above. In fact, you might even already have a J-Mount from another satellite service like Dish Network. They are widely available, affordable, and extremely versatile. One of the best mounting solutions for Starlink is the J-Mount. For a roof installation, a Flashing Mount might be the best option. For example, if you want to install on an exterior wall, an adjustable J-Mount or Starlink Wall Mount would be appropriate. ![]() The structure you will be mounting to will determine what type of mount you need. In this section we will cover the various Starlink mounting options. Once you’ve found a suitable location for your Starlink dish that is free of obstructions according to the Starlink app, you can proceed to picking a mount for a permanent installation. An extension pole or even a dedicated tower might be necessary If you have a lot of tall tree’s and the peak of your roof isn’t high enough, you’ll need to go higher. Or move it to the other side of the roof away from tall objects The dish will have to either be mounted higher, or further away from the obstructions. Proceed to pick the mount type that works best for that location Check the table below to see which kinds of mounts will be best for you based on how obstructed the view is from your test mounting location: Obstructions Allow the app to collect data for at least 12 hours, and then check back later to see how your view is. The second method: If possible, set up your dish with the included tripod mount in a suitable area around where you think you would like to permanently mount it. ![]()
0 Comments
Leave a Reply. |